■ FIGURE 6
■ FIGURE 7
■ FIGURE 8
module in our coordinator satellite.
Load up the X-CTU software and
select the com port that is associated with the RS-232 development
board as shown in Figure 6.
Apply power to the RS-232
development board (included in
the kit). Select the Modem
Configuration tab and hit the
read button. Once the read is
complete, select the ZIGBEE COOR
DINATOR AT function set as shown in
Figure 7 and hit the Write button.
Once the write is complete, hit
the Read button. You need to set a
few of the parameters. You can do this
manually or use the XB2coord.pro file
included in the downloads.
The fields that are changed
include the following:
■ FIGURE 9
■ FIGURE 10
• PAN ID = 234
• Destination Address Low = FFFF
• Node Identifier = COORDINATOR
• Packetization Timeout = 25
Once the values are changed, hit
the Write button. Make sure you label
the module so you can keep track.
Router/End Device Setup
Take the UFL based module, the
UFL-to-SMA adapter cable, and an
SMA antenna as shown in Figure 8.
Plug the module into one of the
development boards and attach the
antenna. In this case, I’m going to use
one of the USB development boards.