Select the PIC16F1619 package type.
In the upper left corner of the Pin Manager: Grid
[MCC] (Section 5), for Package, select “PDIP20” as shown
in Figure 2. Set up the System parameters.
In the System Module (Section 4), set
System Clock Select to “INTOSC;” for
Internal Clock, select “ 16 MHz_HF.” Also,
insure that Low-voltage programming
Enable is checked (Figure 3). Identify the pins to be used.
In the Pin Manager: Grid[MCC]
(Section 5) on the GPIO input row, select
the “lock” icon for pin 6 (Port C4), pin 16
(Port C0), and pin 19 (Port A0). On the
GPIO output row, select the lock icon for
pin 2 (Port A5), pin 3 (Port A4), pin 5
(Port C5), pin 7 (Port C3), and pin 17
(Port A2). Note that Figure 4 shows the
pin selections for GPIO, as well as the settings for the
other device resources to be added in subsequent steps.
December 2017 35
FIGURE 3. System Module setup.
FIGURE 4. Pin Manager grid.
FIGURE 2. IC package type.
MICRO LINEAR ACTUATORS
Make your machine move