The Ultimate Utility Meter — Part 1
female header and connect them to E1 and E2.
Jumper 8
P1 ————————— L2
P2 ————————— L3
Solder two wires to
the UART switch and to
a two-pin female header
and connect them to L2
and L3.
Jumper 9
C5 ————————— K3
Connect the single
one-pin, female-to-female
header.
Figure 17. Jumper locations for the
serial graphic LCD module.
Figure 18. Jumper locations for
the utility module.
Jumper 10
B1 through B7 to A1 through A7
This concludes all the jumper connections. We are
now ready to load up some software and perform some
basic tests.
Connect seven pins, B1 through B7, to A1 through A7
via a seven-pin, female-to-female header.
Step 14:
Load the Dios compiler and connect a nine-pin serial
cable from the UUM to the PC. Figure 19 shows the three
We’re
Back!
Robotic Arm Kit
(No. 4-523)
Twin Motor Gearbox Kit
(No. 3-709)
For All Your Ro
Yes! The internet’s first and best
robotics source has been purchased
by Jameco Electronics, and we’re
committed to greatly expanding the
product line quickly!
Each month we’ll add hundreds more
new robotics products. Plus we’ll
continue to supply favorites like
Muscle Wire®, the OctoBot Survivor™
robot and more.
Be sure to visit us online at
www.RobotStore.com
or call
1.800.374.5764
...and see what’s changed!
botic Needs!
JULY 2005
Circle #66 on the Reader Service Card.
57