TDL® Technology, Inc., has
announced their Model 409, Main-Powered Stereo RIAA Phono Preamp
especially designed to drive a sounds
card’s line-input for restoring 33-1/3
RPM records which were recorded
using standard RIAA equalization. The
preamp uses low-noise op-amps and
powered, its noise and hum levels are
essentially the same as their model 403
battery-powered stereo RIAA phono
Single quantity price is $202 USD
plus shipping. Availability is stock to
four weeks. A full data sheet and User
Guide in PDF format can be downloaded from the TDL Technology
a cast aluminum enclosure for very low
output noise and very low power line
hum pickup. Although the 409 is mains-
The Standard for checking
Good enough to be the
choice of Panasonic,
Pioneer, NBC, ABC, Ford,
JVC, NASA and thousands
of independent service
Locate shorted or leaky
components or conditions
to the exact spot in-circuit
Still cutting up the pcb,
and unsoldering every
part trying to guess at
where the short is?
Your DVM shows the same shorted reading all
along the pcb trace. LeakSeeker 82B has the
resolution to find the defective component.
And with a 60 day trial period, satisfaction Touch pads along the trace, and LeakSeeker
guaranteed or money-back policy, the only beeps highest in pitch at the defect’s pad. Now
thing you can lose is all the time you’re you can locate a shorted part only a quarter of
currently spending on trying to repair all an inch away from a good part. Short can be
those dogs you’ve given up on. from 0 to 150 ohms
CapAnalyzer 88A LeakSeeker 82B
Available at your distributor, or call 561-487-6103
Electronic Design Specialists
Inexpensive enough to pay for itself in just
one day’s repairs. At $199, it’s affordable.
For more information, contact:
TDL Technology, Inc.
5260 Cochise Trl.
Las Cruces, NM 88012
NanoCore12™ for best performance and price!
9S12C microcontroller modules starting at $45!
• on-board RS232C interface
• up to 33 I/O lines, with multi-property programmability
(e.g. direction, pull-up/pull-down,
reduced drive, invert polarity, etc.)
• up to 8 key wake-up interrupt
inputs, with digital filtering
• SCI • SPI • CAN
• 8-channel 10-bit ADCs
• multiple PWM channels
• 4-channel timers, supporting
input capture/output compare,
event counting, gated time
accumulation, and simple PWM
• 32K multi-sector Flash • 2K RAM
• operates up to 48MHz via PLL
• 3. 3 V or 5 V operation
• advanced CISC architecture
• on-chip Serial Monitor
• supports BDM debugging
i -co patible w p n m ith BASIC Sta p2 mm ® O m E (1K): fro $23 SMingle: fro $45
(USA & Canada)
™NanoCore12 is a trademark of Technological Arts, Inc.
® BASIC Stamp is a registered trademark of Parallax, Inc.
REB FLUSH MOUNT
The invention of the REB Flush
Mount Plug Adaptor offers a new
concept to abut a power cable with a
flush fit against a wall, rather than having it extend outward from the wall, as
is most common. This product adapts
standard direct insert power cords into
flush mount inserts by simple plugging
the cord into the REB, which then flush
mount into the receptacle.
Very simple in design and use, the
REB Adaptor immediately eliminates
the problems associated with cables that
extend outward from a power receptacle or standard power adaptor plugs.
The 45 degree angle of the female
receptacle is more effective at holding
the cord in place without pulling. This
product is compatible with all standard
electrical cords and outlets.
The REB Flush Mount Plug Adaptor prevents hazards associated with
compacted or ill fitting connections,
including bent prongs, frayed wiring,
and the possibility of electrical fires.
For more information, contact:
313 Commerce Dr.
Pawleys Island, SC 29585