KC-5490 $46.50 plus postage & packing
This kit intercepts and alters the signal from engine sensors
that supply a voltage signal to the engine control unit
(ECU). Restore correct air/fuel ratios
after engine modifications,
prevent engine boost cuts;
or alter sensor signals
hand controller for
programming, RS232 cable
and a suitable input signal.
Kit includes PCB, case and
Recommended with this kit:
Hand Controller Cat. KC-5386 $39.50
RS232 Cable Cat. WC-7502 $7.00
KC-5488 $23.25 plus postage & packing
Avoid unnecessary noise and vibration in twin-engine boats.
For optimum performance, both motors should run at exactly
the same RPM. You can tune the engine speeds using the
tacho for each engine, however tachos have an error of up to
5%. The Engine Speed Equalizer Kit takes the tacho signals
from each motor and displays the output on a meter that is
centred when both motors are running at the same RPM.
When there's a mismatch, the meter shows which
motor is running faster and by how much.
You simply adjust the throttles to suit.
Short form kit only, requires
moving coil panel meter
(Cat. QP-5010 $9.00).
SPEED EQUALIZER KIT
• PCB and specified components
KC-5466 $12.75 plus postage & packing
Many modern motor bikes use a Capacitor Discharge Ignition
(CDI) to enhance performance and reliability. However
replacement CDI ignition modules can be very expensive.
This kit will replace 1, 2, 3 or 4 cylinder failed
factory units and is suitable for engines with a
positive capacitor voltage and have a
separate generator and trigger
coil. Supplied with solder
masked PCB and overlay,
case and components. Some
mounting hardware required.
KC-5463 $10.50 plus postage &
A handy regulator to run a
variety of devices such
as CD or MP3 players
from your car cigarette
lighter sockets or even
powered speakers from the
power supply inside your PC. It will supply 3V, 5V, 6V, 9V, 12V
or 15V and (when used with an appropriate input voltage and
heatsink) deliver up to four amps at the selected output voltage.
Kit includes screen printed PCB and all specified components.
Heatsink not included.
KC-5479 $46.50 plus postage & packing
Prolongs the life of your lead acid batteries. Like the original
2005 project, this circuit produces short high level bursts of
energy to reverse the sulfation effect. The
battery condition checker is no longer
included and the circuit has been
updated and revamped to provide more
reliable, long-term operation. It still
includes test points for a DMM and
binding posts for a battery charger. Not
recommended for use with gel batteries
FAST NI-MH BATTERY
KC-5453 $25.00 plus postage & packing
Ideal for RC enthusiasts who burn through a lot of batteries.
Capable of handling up to 15 of the same type of Ni-MH or
Ni-Cd cells. Build it to suit any size cells or cell capacity and
set your own fast or trickle charge rate. Features overcharge
protection and temperature sensing. Kit
includes solder mask & overlay PCB,
programmed micro and specified
Case, heatsink and
battery holder not
• PCB with solder mask
and overlay components
• Screen printed machined case
• 6, 12 & 24VDC
KC-5446 $10.00 plus
postage & packing
This handy voltage regulator can
provide up to 1,000mA at any
voltage from 1.3 to 22VDC.
Ideal for experimental projects
or as a mini bench power supply.
Heatsink may be regulated
depending on output current. Kit
supplied with PCB and electronic
KC-5482 $46.50 plus postage & packing
Checks the health of your SLA
batteries prior to charging or zapping
with a simple LED condition indication
of fair, poor, good etc. An ideal
companion to our Battery
MONITOR KIT KC-5424 $13.50 plus
postage & packing
Monitors either the battery voltage, airflow meter or oxygen
sensor in your car. This versatile 12VDC kit features a 10 LED
bar graph that indicates the measured voltage in 9-16V,
0.-5V or 0-1V ranges. Features fast
response time, high input impedance
and auto dimming for night time
driving. Kit includes PCB with overlay
and all electronic components.
• Overlay PCB and electronic components
• Silk-screened front panel and
machined case included
POST & PACKING CHARGES
Order Value Cost
$25 - $49.99 $7.50
$50 - $99.99 $20
$100 - $199.99 $40
$200 - $499.99 $60
Note: Products are dispatched from Australia,
so local customs duty & taxes may apply .
Prices valid until 31/3/10
Max weight 12lb (5kg).
Heavier parcels POA.
Minimum order $25.
HOW TO ORDER
•ORDER ON-LINE: www.jaycar.com
• PHONE: 1-800-784-0263
• FAX: + 61 2 8832 3118*
• EMAIL: firstname.lastname@example.org
• POST: P.O. Box 107, Rydalmere NSW 2116 Australia
• ALL PRICING IN US DOLLARS
•MINIMUM ORDER ONLY $25
*Australian Eastern Standard Time (Monday - Friday
09.00 to 17. 30 GMT + 10 hours only)
Expect 10-14 days for air parcel deliver y
We have kits & electronic
projects for use in:
• Audio & Video
• Car & Automotive
• Computer • Lighting
• Power • Test & Meters
• Learning & Educational
• General Electronics Projects
• Gifts, Gadgets & Just for fun!
For your FREE catalog logon to
or check out the range at