NEW PRODUCTS ■ HARDWARE ■ SOFTWARE ■ GADGETS ■ TOOLS
The new 32 pitch/24 tooth
users to build right
angle drives inside or outside of channel. These bevels work
well for building differentials or any application where you
need to transfer rotational motion 90 degrees.
Now offering both metric
( 4 mm - 6 mm) and SAE (1/4") bore diameters, these gears
are appropriate for all kinds of applications. Simply slide
the gear on the shaft and tighten the set screw. They are
manufactured from hardened brass gear stock for extreme
durability and strength. Prices start at $5.99/each.
Aredesigned heavy duty linear servo is also now available from ServoCity. While a linear servo may
appear similar to a linear actuator, it runs on a completely
different signal. The linear servo can plug into just about
any servo controller — wired or wireless. The advanced
internal circuit board reads the PWM signal received from
the servo controller and will precisely control the position
of the linear servo. A PID algorithm is used in order to
minimize settling time and overshoot.
The 24 kHz PWM output frequency creates very
smooth movements without any PWM noise. The internal
board is nearly bullet-proof as it's protected against reverse
polarity, over-current, and over-temperature. There is a built-in circuit (BEC) that supplies power (5V, 500 mA) to your
servo controller so that everything can be powered off a
single power source. The aluminum construction ensures
tremendous durability and reliability.
These linear servos are offered in stroke lengths from
two inches up to 12 inches; the extension shaft is .785" in
diameter. Mounting points are 5/16" diameter and are
directly compatible with various ServoCity mounting
brackets. Prices start at $299.99/each.
For more information, contact:
If you have a new product that you would like us to run in
our New Products section, please email a short description
(300-500 words) and a photo of your product to:
26 October 2014